|
View previous topic :: View next topic |
Author |
Message |
velrajkumar.g SEFI Regulars
Joined: 30 Mar 2013 Posts: 21
|
Posted: Fri Jul 24, 2020 9:54 am Post subject: Dimension of Standard steel- Reg |
|
|
Where we measure the thickness of flange of I beam and design which one we take for outer edge or inner edge of flange
Last edited by velrajkumar.g on Sun Jul 26, 2020 8:11 am; edited 1 time in total |
|
Back to top |
|
|
Dr. N. Subramanian General Sponsor
Joined: 21 Feb 2008 Posts: 5538 Location: Gaithersburg, MD, U.S.A.
|
Posted: Sat Jul 25, 2020 1:08 am Post subject: Re: Dimension of Standard steel- Reg |
|
|
Dear Er Velrajkumar
You need to ask your supplier about this!
Best wishes
NS
velrajkumar.g wrote: | Dear sir,
I was purchased rolled steel I section from local market in Coimbatore,India, Dimension of section as follows
Overall depth of section is 125 mm, Width of section is 65mm,Thickness of flange and web is 5mm.
As per steel table, thickness of flange and web for rolledsection is not same.
Why the thickness of flange and web is not same.
Regards
Velrajkumar |
|
|
Back to top |
|
|
es_jayakumar General Sponsor
Joined: 24 Nov 2011 Posts: 1408 Location: Cochin
|
Posted: Sun Jul 26, 2020 12:11 pm Post subject: |
|
|
Can it be due to the fact that the local re-rolling mills are making the structural steel sections without any reference to the Standards ?
E S Jayakumar |
|
Back to top |
|
|
rsharma SEFI Member
Joined: 05 Apr 2011 Posts: 1 Location: Mumbai
|
Posted: Mon Jul 27, 2020 8:30 am Post subject: Dimension of Standard steel- Reg |
|
|
Check if product has IS mark?If yes, you can also complain to BIS.
Sent from Yahoo Mail on Android
Posted via Email |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
|
|
|